Back4.1.2.2.(1)

ATTRIBUTION:

Functional Statement:

F20

To support and withstand expected loads and forces.

Objective:

OS2.1

 

APPLICATION:

Loads, forces and effects that can be expected due to the intended use, but are not listed in Article 4.1.2.1., to be taken into account in the design of buildings and structural components.
This applies to buildings described in Sentence 1.3.3.2.(1) of Division A and buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A] that are required to be designed to the requirements of Part 4.

INTENT:

To limit the probability that expected loads, other than those listed in Article 4.1.2.1., will not be taken into account in the design of the structural components of the building, which could lead to structural failure, which could lead to harm to persons.

ATTRIBUTION:

Functional Statement:

F20

To support and withstand expected loads and forces.

F22

To limit movement under expected loads and forces.

Objective:

OP2.1, OP2.4

 

APPLICATION:

Loads, forces and effects that can be expected due to the intended use, but are not listed in Article 4.1.2.1., to be taken into account in the design of buildings and structural components.
This applies to buildings described in Sentence 1.3.3.2.(1) of Division A and buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A] that are required to be designed to the requirements of Part 4.

INTENT:

To limit the probability that expected loads, other than those listed in Article 4.1.2.1., will not be taken into account in the design of the structural components of the building, which could lead to:
  • excessive deformation of, or excessive stress in, structural components, which could lead to damage to the building, and
  • excessive deflection or excessive vibration of structural components, which could impede the intended use and occupancy of the building.

ATTRIBUTION:

Functional Statement:

F22

To limit movement under expected loads and forces.

Objective:

OH4

 

APPLICATION:

Loads, forces and effects that can be expected due to the intended use, but are not listed in Article 4.1.2.1., to be taken into account in the design of buildings and structural components.
This applies to buildings described in Sentence 1.3.3.2.(1) of Division A and buildings to which Part 9 applies [see Sentence 1.3.3.3.(1) of Division A] that are required to be designed to the requirements of Part 4.

INTENT:

To limit the probability that expected loads, other than those listed in Article 4.1.2.1., will not be taken into account in the design of the structural components of the building, which could lead to excessive deflection or excessive vibration of the structural components, which could lead to negative effects on the psychological well-being of persons.