4.1.6.3.(1)ATTRIBUTION:
Functional Statement:
F20
To support and withstand expected loads and forces.
Objective:
OS2.1
APPLICATION:
Distribution of specified snow load stated in Sentence
4.1.6.2.(1) on roofs or other building surfaces subject to snow accumulation, for the design of structural elements of buildings.
This applies to buildings described in Sentence
1.3.3.2.(1) of Division A and
to buildings to which Part 9 applies [see Sentence
1.3.3.3.(1) of Division A for application of Part 9] that are required
to be designed in accordance with the requirements of Part 4.
INTENT:
To limit the probability that the distribution of snow load
will not take into account the maximum expected snow accumulation over the
whole span of structural elements supporting the roof, which could lead to
high stresses in these elements, which could lead to structural failure, which
could lead to harm to persons.
ATTRIBUTION:
Functional Statement:
F20
To support and withstand expected loads and forces.
F22
To limit movement under expected loads and forces.
Objective:
OP2.1, OP2.4
APPLICATION:
Distribution of specified snow load stated in Sentence
4.1.6.2.(1) on roofs or other building surfaces subject to snow accumulation, for the design of structural elements of buildings.
This applies to buildings described in Sentence
1.3.3.2.(1) of Division A and
to buildings to which Part 9 applies [see Sentence
1.3.3.3.(1) of Division A for application of Part 9] that are required
to be designed in accordance with the requirements of Part 4.
INTENT:
To limit the probability that the distribution of snow load
will not take into account the maximum expected snow accumulation over the
whole span of structural elements supporting the roof, which could lead to
high stresses in these elements, which could lead to the excessive deformation
of, or excessive stress in, the structural elements, which could lead to damage
to the building.