Division B
Acceptable Solutions

Part 5 — Environmental Separation

(See Appendix A.)  (See Part 10)

[Rev. 2, B.C. Reg. 73/2008.]

Section 5.3. Heat Transfer

(See Appendix A.)

5.3.1. Thermal Resistance of Assemblies

5.3.1.1. Required Resistance to Heat Transfer
(See Appendix A.)

1) [ . . . ] Where a building component or assembly will be subjected to an intended temperature differential, the component or assembly shall include materials to resist heat transfer or a means to dissipate transferred heat in accordance with the remainder of this Subsection, and Article 1.3.3.7. of Division A or Section 9.25. of Division B.I

2) Deleted.I

5.3.1.2. Properties to Resist Heat Transfer or Dissipate Heat
(See Appendix A.)

1) Taking into account the conditions on either side of the environmental separator, materials and components installed to provide the required resistance to heat transfer or the means implemented to dissipate heat shall provide sufficient resistance or dissipation,I

a)to minimize surface condensation on the warm side of the component or assembly,

b)in conjunction with other materials and components in the assembly, to minimize condensation within the component or assembly,

c)in conjunction with systems installed for space conditioning, to meet the interior design thermal conditions for the intended occupancy, and

d) to minimize ice damming on sloped roofs.

(See Appendix A.)

2) Except as provided in Sentence (3), all metal-framed glazed assemblies separating interior conditioned space from interior unconditioned space or exterior space shall incorporate a thermal break to minimize condensation.I

3) Metal-framed glazed assemblies need not comply with Sentence (2) where these assemblies areI

a)storm windows or doors, or

b)windows or doors that are required to have a fire-protection rating.

(See Appendix A.)
5.3.1.3. Location and Installation of Materials Providing Thermal Resistance

1) Where a material required by Article 5.3.1.1. is intersected by a building assembly, penetrated by a high conductance component or interrupted by expansion, control or construction joints, and where condensation is likely to occur at these intersections, penetrations or interruptions, sufficient thermal resistance shall be provided so as to minimize condensation at these locations.I

2) Materials providing required thermal resistance shall have sufficient inherent resistance to airflow or be positioned in the assembly so as to prevent convective airflow through and around the material.

(See Appendix A .)

I

3) Spray-in-place polyurethane insulation shall be installed in accordance with the requirements of CAN/ULC-S705.2, “Thermal Insulation–Spray-Applied Rigid Polyurethane Foam, Medium Density, Installer's Responsibilities - Specification”.I