Division A
Compliance, Objectives and Functional Statements

Part 3 — Functional Statements

Section 3.2. Functional Statements

3.2.1. Functional Statements

3.2.1.1. Functional Statements
1) The objectives of this change beginBy-lawchange end are achieved by measures, such as those described in the acceptable solutions in Division B, that are intended to allow the plumbing system to perform the following functions (see Appendix A):
F01 To minimize the risk of accidental ignition.
F02 To limit the severity and effects of fire or explosions.
F20 To support and withstand expected loads and forces.
F21 To limit or accommodate dimensional change.
F30 To minimize the risk of injury to persons as a result of tripping, slipping, falling, contact, change beginassault,change end drowning or collision.
F31 To minimize the risk of injury to persons as a result of contact with hot surfaces or substances.
F40 To limit the level of contaminants.
F41 To minimize the risk of generation of contaminants.
F43 To minimize the risk of release of hazardous substances.
F45 To minimize the risk of the spread of disease through communal shower facilities.
F46 To minimize the risk of contamination of potable water.
F62 To facilitate the dissipation of water and moisture from the building.
F70 To provide potable water.
F71 To provide facilities for personal hygiene.
F72 To provide facilities for the sanitary disposal of human and domestic wastes.
F80 To resist deterioration resulting from expected service conditions.
F81 To minimize the risk of malfunction, interference, damage, tampering, lack of use or misuse.
F82 To minimize the risk of inadequate performance due to improper maintenance or lack of maintenance.
F83 change beginTo control the amount of water a plumbing fixture will use.
F84 To control the flow of water to a plumbing fixture or outlet.
F85 To minimize thermal loss or gain.
F86 To minimize the use of energy for building systems.change end

contentHistory